IF Fullclean Foam

IF Fullclean Foam is an alkaline active cleaning agent Whiteh a very long bonding time and particularly good cleaning capacity.

The foam is characterized by:

• Very long bonding time, up to 2 hours after application, also on plastic walls! This allows the active components to work longer on the dirt and at the same time keep the surface moist.
• High content of complexing agent.
• The combination of high alkalinity and high chelating power gives improved degreasing in areas Whiteh hard water.
• It offers excellent protein and fat solubility.
• The active foam is a dynamic foam! Penetrates very well into the dirt and keeps the dirt in solution through the emulsifiers and dispersers.
• Economical in use.

Contains: NaOH, KOH, complexing agents, humidifiers, foaming agents, emulsifiers and dispersants.

Directions for use: Apply by means of IF Applicator to 2%. Leave foam for 1-2 hours and rinse.

Packaging: 24 kg, 60 kg, 224 KGand 1000 kg.

Guidance on the safe handling practices and conditions for safe storage and transport are on the safety data sheet.

Why foam? The detergent adheres to the surface to be cleaned by means of foam technology. Lye Whitehout foaming agent runs directly from the surface, so there is no effective cleaning. By attaching foam longer, the foam bubbles work on the dirt. After a while, the foam bubbles burst and they take the dissolved dirt down. Foam bubbles then start to settle on the dirt that has not yet been soaked away. After some time these foam bubbles also burst and they take the dissolved dirt down again. By a repetition of the foregoing, a very effective cleaning is obtained.

Dynamic foam: Good cleaning and degreasing is achieved by: a longer bonding time of the dynamic foaming agent sufficient active substances (NaOH, complex formers, emulsifiers and dispersers) a good application technique (IF Applicator: correct dosage, perfect foaming agent,) use on dry walls and apply surfaces everywhere